Binachem Epoxy MR

BINACHEM EPOXY MR can be used for following applications.

• Grouting in fixing bolts & anchors
• Grouting holes and cavities in concrete elements
• Crane rail & railroad track rehabilitation
• Precision alignment under dynamic load conditions
• Transfer car runways & material handling tracks
• The maintenance and repair of marine structures.
• Bridge bearings and filling the empty space between the steel
reinforcement of reinforced concrete columns.

• Packaging: 9 Kg Set (A+B) & 30 Kg Set (A+B) / 
Comp A: Epoxy Resin, Comp B: Epoxy Hardener / 
Comp C: Filler

Approximate coverage

*Coverage data are for general guidance. Actual consumption depend upon substrate, application techniques & wastages etc.


Component A and B are mixed under low speed mixer for 3-4 minutes, then component C is poured into the mixture and all
of them mix for 3-5 minutes until obtaining homogenous mixture. Mixture must be applied in 40 minutes. Mixture should be
applied on the surface with using a trowel as obtained maximum 40 mm thickness. Maximum thickness can be achieved up to
200mm with multiple layers (each layer must not exceed 40mm)
Depending on the weather conditions 10-48 hours should be waited for next layers.
The product would be completely cured in minimum 7 days.